NEC DS1000 Release Notes

DS1000 02.10.09 Release Notes
New Features in 02.10.09
DS1000 Release Notes 17 ◆ 02.10.09
5. Press YES to unlock the extension entered in step 4 above.
OR
Press NO to go back to step 3 without unlocking.
6. When you have unlocked all extensions desired, press CONF to exit.
Walking Class of Service
Feature Available
Walking Class of Service allows an extension user to temporarily implement their Toll Restriction
and Class of Service settings at a co-worker’s phone. This is normally used to override dialing
restrictions at a telephone. For example, an executive with an unrestricted phone can walk to any
phone in the building, implement Walking Class of Service, and dial without restriction. After the
phone goes idle, Walking Class of Service remains in effect for 10 seconds. This permits the user
to make multiple calls before the phone returns to its normal restrictions.
When an extension user implements Walking Class of Service and places a trunk call, the system
assigns the SMDR record to the users’s extension. The system does not assign the record to the
extension at which the call was placed. For example, if the extension 301 user walks to extension
306, implements Walking Class of Service and dials a trunk call, the SMDR record is assigned to
extension 301. It is not assigned to extension 306.
Note: Walking Class of Service overrides Extension Locking. For example:
● Extension 301 is permitted by their Class of Service and Toll Restriction to use Paging and
place long distance calls.
● Extension 306 locks their extension. While locked, Class of Service 15 prevents Paging and Toll
Level 7 prevents long distance calls. These features are no longer available at extension 306.
The COS 15 options must be separately programmed.
● The extension 301 user goes to extension 306 and implements Walking Class of Service.
● The extension 301 user can then use 306 to make long distance calls and Page (even though
306 was locked to prevent those features).
Programming
0101-Day Walking Class of Service
Enter Y to enable or N to disable Walking Class of Service while the system is in the day mode.
This option affects the extension implementing this feature, not the extension at which the feature is
being used. For example, if the extension 301 user goes to extension 305 and tries to use Walking
Class of Service during the day, this option must be enabled for extension 301. This option is dis-
abled by default.
0101-Night Walking Class of Service
Enter Y to enable or N to disable Walking Class of Service while the system is in the night mode. This
option affects the extension implementing this feature, not the extension at which the feature is being
used. For example, if the extension 301 user goes to extension 305 and tries to use Walking Class of
Service at night, this option must be enabled for extension 301. This option is disabled by default.
1801-Exension Class of Service Assignment
Assign Class of Service to extensions.
1807-PIN Code
Use this option to assign a PIN code to an extension. PIN codes are 4 digits long, using 0-9, # and

NEC DS1000 Specifications

General

Brand	NEC
Model	DS1000
Category	Telephone
Language	English