NEC DSX-160 - Removing the Cover

Installing the Main Equipment Cabinet
DSX-80/160 Hardware Manual Installation ◆ 23
Installation
Figure 2: Installation Layout, DSX-160
Removing the Cover
Before wall-mounting, remove the cover on the Main Equipment Cabinet.
To remove the cover:
1. Unscrew the two captive screws on the front of the cabinet cover.
2. Lift up slightly on the front of the cover — then gently slide the cover back to remove it.
Figure 3: Removing the Cover
15
Surge
Protector
To earth
ground
To telco
ground
Station
Blocks
Line
Blocks
Station
Blocks
Dedicated
AC Outlet
Note: The system will respond to telco ring signal in the
range of 40-130 VAC @ 20 Hz.
80000 - 12
DSX-80 4-Slot KSU Shown