Installing the Power Supply
DSX-80/160 Hardware Manual Installation ◆ 29
Installation
Installing the Power Supply
Power Supply Installation
The power supply provides the DC power sources required to operate the system.
To install a power supply:
1. Slide the power supply into the CN101 slot.
2. Using a long-shaft phillips head screwdriver, tighten the two screws that secure the power supply.
A DSX-160 may require up to 3 power supplies (depending on system configuration), using slots CN101,
CN102 and CN103. Refer to System Preparation (page 21) for more.
When installing multiple power supplies in DSX-160:
1. Install the first supply in slot CN101.
2. Install the second supply in slot CN103.
3. Install the third supply in slot CN102.
Figure 11: Installing the Power Supply
Important
In case of fire, disconnect the power cord from the AC outlet.
1093096 - 12
DSX-80 4-Slot KSU Shown
To Next Page
Loading...
