Grounding the Cabinet
26 ◆ Installation DSX-80/160 Hardware Manual
Grounding the Cabinet
Removing the Right Side Panel
Remove the cabinet right side panel to gain easy access to the ground lugs and system cabling. The cabinet
has two ground connections: ETH (Earth Ground) and PBXG (PBX Ground).
To remove the right side panel:
1. Remove the two screws that secure the right side panel to the cabinet.
2. Carefully slide the right side panel down until it swings clear of the cabinet.
Figure 8: Removing the Right Side Panel
80000 - 16
DSX-80 4-Slot KSU Shown
To Next Page
Loading...
