NEC DSX-160 - Securing the Cables; Making Your Own Cables; Making Your Own Installation Cables

Installing Cards
DSX-80/160 Hardware Manual Installation ◆ 39
Installation
Securing the Cables
After you have punched down your cables, route them through the side of the cabinet and secure them with
the strain relief.
Figure 21: Securing the Cables
Making Your Own Cables
Making Your Own Installation Cables
The following products should help if you make your own cables. The connector is generally referred to
as a RJ45 connector wired in an RJ61X configuration. Check with your local supplier for other compa-
rable products.
❥ Suttle SE-266-8K 8 Position Modular Plug (requires an SE-166 or SE-166-6 modular crimping tool).
❥ Hubbell BRFT4P Snap-On 8 Position Modular Plug (does not require a special crimping tool).
Figure 22: 8-Pin (RJ61X) Jack Pinouts
8
0000 - 33
RJ61X
Pin
Latch
faces up
To CPU
Mod Jack
Note
reversal
Port
Designation
To 66 Block
WHT-BLU (1T)
BLU-WHT (1R)
WHT-ORN (2T)
ORN-WHT (2R)
WHT-GRN (3T)
GRN-WHT (3R)
WHT-BRN (4T)
BRN-WHT (4R)
80000 - 18C
4T
3T
2T
1R
1T
2R
3R
4R
1
2
3
4
5
6
7
8