NEC Dterm DTL-8R-1 - Page 55

D
term
Cordless DECT Document Revision 1
Owner’s Guide 6 - 7
___________________________________________________________________________________
___________________________________________________________________________________
2.2 Making a Call to Another Extension
To make a call to another extension:
1. Press the TALK key on the Handset. The Handset tries to connect to
the Base Station while the “ACQUIRING LINK” message blinks on the
LCD (ON: 300 msec, OFF: 300 msec).
2.
When connected, the Handset goes into Talk Mode and Talk icon is turned
on and shows current volume for two seconds. If the PBX sends any
message during this time, the LCD shows the message after the volume
display.
3. If the user dials 1, 0, 2 the LCD shows the dialed number as they are
pressed.
 When Base Station is not connected to a PBX, the Handset displays
“DISCONNECT”.
 When the Handset cannot connect to the Base Station, an error tone is
emitted and "Out of Range” is displayed for five seconds on the LCD and the
Handset goes into Standby Mode.
 The Handset cannot go into Talk Mode when the wired phone is selected.
Vol u me
L
o
w
H
i
g
h
DI SCONNECT
Out of Range
Dterm Cordless DECT.book Page 7 Friday, December 7, 2007 3:48 PM