6 - 8 Setup and Operation
___________________________________________________________________________________
___________________________________________________________________________________
Document Revision 1 D
term
Cordless DECT
2.3 Making Call to Outside Line
To make an external call:
1. Press the F1 key or assigned line trunk key on the Handset. The
Handset starts to establish an RF connection with the Base Station. The
LCD does not change.
2.
When the RF connection is established, the Handset goes into Talk Mode
and the Talk icon is turned on. The current volume is shown on the LCD for
two seconds and the line key LED is turned on. If the PBX sends any
message during this time, the LCD shows the message after the volume is
displayed.
3. The LCD shows this message to prompt the user to dial the numbers.
4. If the user dials 1, 2, 3, the LCD shows the dialed numbers in the LCD
display.
5. About 10 seconds later, the call time is displayed on the LCD.
Vol u me
L
i
h
01：
0：0 0
Dterm Cordless DECT.book Page 8 Friday, December 7, 2007 3:48 PM
To Next Page
Loading...
