6 - 10 Setup and Operation
___________________________________________________________________________________
___________________________________________________________________________________
Document Revision 1 D
term
Cordless DECT
2.5 Redial (Option)
When the RF link is established between the Handset and the Base Station,
the user can press the REDIAL key. The last number dialed is shown and the
digits dialed are sent to the Base Station.
Error tone is emitted when redial is empty.
Dial limit is 32 digits, redial stores up to 32 digits in memory.
Redial data is stored in Handset memory (EEPROM).
If F1~F12 keys are pressed the number dialed before the Function key is pressed is
stored in redial memory.
Example:
(1) [talk][1][2][3][talk] redial: 123
(2) [talk][1][2][3]……….[1][2][talk] (over 32 digits) redial: 123……12 (up to 32 digits)
(3) [talk][1][2][3][F1][4][5][6][talk] redial: 123
2.6 AutoStandby
®
When the Handset is in one of the modes listed below, placing the Handset on
the Charger changes it to Standby Mode. At this time, a confirmation tone is
emitted.
Ringer volume setting
Menu setting
Tal k Mo de
Trying to connect to the Base Station
Dterm Cordless DECT.book Page 10 Friday, December 7, 2007 3:48 PM
To Next Page
Loading...
