NEC Dterm DTL-8R-1 - Page 59

D
term
Cordless DECT Document Revision 1
Owner’s Guide 6 - 11
___________________________________________________________________________________
___________________________________________________________________________________
2.7 PBX No Service
1. When the TALK or Speaker key is pressed, while the Base Station is
using a wired phone, the LCD displays the following for five seconds with
an error tone, and returns to Standby Mode.
2.8 Out Of Range
2.8.1 When in Standby Mode
The Handset displays the message “Searching” when the Handset
cannot find the Base Station (Out of Range) in Standby Mode.
2.8.2 When Establishing an RF Link
If the TALK, Speaker or F1~F4 key is pressed and the Handset
cannot establish an RF Link with the Base Station, the Handset
sounds an error tone and displays the message “Out of Range”.
No Service
Dterm Cordless DECT.book Page 11 Friday, December 7, 2007 3:48 PM