NEC Electra Elite IPK - CONFERENCE CALLS; Establishing a Conference Call; CONFERENCE BRIDGE; Using the Conference Bridge

1 - 4 Electra Elite IPK IAD(8)-U( ) ETU
___________________________________________________________________________________
___________________________________________________________________________________
Document Revision 4 MEGACO Station
2.2 Switch Settings
The IAD(8)-U( ) ETU has two switches that are described below.
 Switch S1 is a Press to Reset switch.
 Switch S2 is a Card Configuration switch. Refer to Table 1-3 IAD(8)-U( )
ETU Switches.
2.3 Connectors
This ETU has the following connectors:
 P1 Connects to the backboard
 J1, J10, J11 Reserved for future use
 J5 RJ-45 Ethernet connector for future use
 J6 Default RJ-45 Ethernet connector
2.4 Installation
The IAD (8)-U( ) ETU can be installed in any KSU slot that supports the
applicable simulated ETU.
2.5 Pushbutton Switch
S1 is the reset switch.
Table 1-3 IAD(8)-U( ) ETU Switches
Reserved Auto Sense No. of Ports
ESI(8)-U10 ETU Mode
of Operation
SW1 SW2 SW3 SW4 SW5 SW6 SW7 SW8
OFF OFF OFF ON ON ON OFF OFF
1~3 always OFF
(Reserved)
Auto Card
Discovery
Selection - for
ESI(8)-U( ) ETU
simulation - must
be set to ON
Number of Voice
Ports - always ON
to enable 8 ports
Mode Selection to
show simulated ETU