MEGACO Station Document Revision 4
Hardware, Installation and Maintenance Manual A - 11
___________________________________________________________________________________
___________________________________________________________________________________
SECTION 7UPLOAD
The software package on the IAD(8)-U( ) ETU can be upgraded via the web browser.
Use this link either to upgrade the Megaco Station package, or to load any other available
package.
When Upload is selected, you are prompted to enter the path name where the station
card package is located. Press Upload. Once the upload is completed, the IAD(8)-U( )
ETU must be reset.
This firmware is provided by NEC and must be stored on your local PC prior to firmware
upload.
Figure A-7 Upload Parameters
To Next Page
Loading...
