A - 10 Setup and Configuration
___________________________________________________________________________________
___________________________________________________________________________________
Document Revision 4 MEGACO Station
SECTION 6RESET CARD
A reset is necessary when changing the operating modes and network parameters (such
as IP address, Subnet mask, gateway address, TOS field etc.).
K
Safe reset - When safe reset is selected, the IAD(8)-U() will only execute the
reset after all terminals are idle and on-hook.
K
Forced reset - If forced reset is selected, the IAD(8)-U() will reboot immediately
preempting any and all stations that are currently off-hook.
Figure A-6 Resetting the Card
To Next Page
Loading...
