NEC Electra Elite IPK - PAGING; Paging Procedures; Meet-Me Answer; Using Meet-Me Answer

Hardware, Installation and Maintenance Manual 4 - 1
___________________________________________________________________________________
___________________________________________________________________________________
Chapter 4 IPK IAD(8)-U( ) Configuration
SECTION 1CONFIGURING IAD(8)-U( ) ETU
When installed for the first time, the IAD(8)-U( ) ETU, comes up with factory set default
parameters as shown in Table 4-1 Factory Network Settings.
In this configuration, the ETU cannot run in any randomly given environment, and its
parameters must be redefined before the IAD(8)-U( ) ETU can work in your environment.
The required parameters can be set by using your web browser and connecting to the default
IP Address (192.168.1.100) in the browser's navigation address bar. Refer to Appendix A
Setup and Configuration for a detailed description of the Web Base Configuration.
SECTION 2PC PARAMETERS
The initial configuration is performed using a PC (or laptop computer) connected to the
IAD(8)-U( ) ETU using a crossover Ethernet cable (one-to-one connection) or connecting with
a hub. Make sure that the PC has the networking parameters set as shown in Table 4-2
Network Settings for the PC.
Table 4-1 Factory Network Settings
Computer Name
neciad
IP Address
192.168.1.100
Subnet Mask
255.255.255.0
Default Gateway
192.168.1.1