NEC Electra Elite IPK - Page 44

C - 2 IP Megaco Station Enhancements
___________________________________________________________________________________
___________________________________________________________________________________
Document Revision 4 MEGACO Station
To set up this example, follow these steps:
1. Configure the IP addresses and net mask settings on the phone and IAD card.
Make sure that the Subnet mask and default gateway settings are correct.
2. IP Phone - Set the MGC address in the IP phone to the address of the IAD card
“144.168.20.2”.
3. IAD (8)-U10 ETU -On the Ports page of the IAD card, enter “144.168.33.4” into
the IP address field of one of the phones, or check the DHCP.
 Make sure that “Outside Firewall” box for this telephone is NOT checked.
4. If you use the “DHCP” option, you must set the Extension in the IP phone to
match one of the station ports assigned to the IAD card in the IPK configuration.
WAN
IP Phone
144.168.33.4
Electra Elite IPK
IAD(8)-U10 ETU
144.168.20.2