9-28 Upgrading Your Server
6. Fix the rails coming with the server to the 5.25-inch device by using the four screws
coming with the device.
IMPORTANT:
Always use the screws coming with the 5.25-inch device. Using
longer screws or those of different diameter may cause the device to
be broken.
When installing a double-height device, use the DLT device rails
that come with the server.
7. Push the 5.25-inch device to the device bay carefully.
NOTE: Make sure that the cables are not caught while the 5.25-inch
device is pushed into the slot.
IMPORTANT: If a 5.25-inch device occupying two slots cannot be
inserted easily, push the device to the slots with it lifted a little.
8. Fix the rails by using the screws removed in step 3.
Half-height device Full-height device
9. Check whether the installed 5.25-inch device is projected too much from the front of the
server.
Check the device installed in a 5.25-inch device bay based on the CD-ROM drive
normally installed.
To Next Page
Loading...
