Upgrading Your Server 9-29
10. Connect the SCSI and power cables to the 5.25-inch device installed from the left side of
the server.
See "Cable connection" for details.
IMPORTANT: Connector pin bending or incomplete connection may
cause a malfunction to occur. Provide the connection securely
watching the 5.25-inch device and cable connectors.
NOTE: Make sure that the cable is not caught.
11. Install the removed components.
IMPORTANT: Run the SCSI cable and CD-ROM drive ribbon cable
as shown in the figure below.
12. Provide the setup for the server referring to "SCSI BIOS" in Chapter 4.
Removal
Remove the 5.25-inch device in the reverse procedure of the installation.
To SCSI connector
on mother board
Not used
To device installed in
slot 1 of 5.25-inch
device bay
To device installed in
slot 2 of 5.25-inch
device bay
Termination
connector
To device installed in
slot 3 of 5.25-inch
device bay
To Next Page
Loading...
