CRU Replacement and Server Upgrades 4-37
1. Perform steps 1 through 3 of the previous subsection Installing PCI Adapter
Boards.
2. Determine the PCI board retaining bracket that corresponds to the desired
expansion slot and remove its setscrew. See Figure 4-48.
Figure 4-48. Removing the PCI Board Retaining Bracket Screw
3. Hold the PCI board at each end, and carefully rock it back and forth until the
edge connectors pull free. Make sure that you do not scrape the board
against other components.
4. Remove the board from the expansion slot and place it in an antistatic
wrapper.
5. If you are replacing a board, go to previous subsection Installing PCI
Adapter Boards, otherwise continue.
6. Install a PCI expansion slot cover over the vacant slot. Secure the expansion
slot to the expansion slot frame with its setscrew removed in step 2.
7. Install a connector cap over the vacant PCI board slot.
8. Perform steps 9 through 11 of the previous subsection Installing PCI
Adapter Boards.
To Next Page
Loading...
