4-52 CRU Replacement and Server Upgrades
4. Label and disconnect all peripheral cables attached to the I/O panel on the
back of the server.
5. Carefully lift the front door up and pull it towards you until it is free of its
top and bottom hinges and then remove it. See Figure 4-62.
Figure 4-62. Removing the Front Door
6. Unscrew and remove the knurled screws securing the top cover to the rear of
the chassis. See Figure 4-63.
Knurled
Screws
Figure 4-63. Removing the Top Cover Rear Screws
To Next Page
Loading...
