NEC Express5800 320La - Page 179

Problem Solving 5-25
Table 5-3. POST Error Codes and Messages (continued)
Error Code and Message Description Action
0230 System RAM Failed at offset DIMM is faulty.
•
Replace DIMM.
•
Replace the CPU module
board.
0231 Shadow RAM Failed at offset DIMM is faulty.
•
Replace DIMM.
•
Replace the CPU module
board.
0232 Extend RAM Failed at
address line
DIMM is faulty.
•
Replace DIMM.
•
Replace the CPU module
board.
0233 Memory type mixing detected DIMMs of the different types
are installed.
•
Replace DIMM with
appropriate one.
0234 Single - bit ECC error DIMM is faulty.
•
Replace DIMM.
•
Replace the CPU module
board.
0235 Multiple - bit ECC error DIMM is faulty.
•
Replace DIMM.
•
Replace the CPU module
board.
0250 System Battery is Dead -
Replace and Run SETUP
No battery is available for
the system.
•
Replace the CPU module
board.
0251 System CMOS Checksum
Bad - Default Configuration
Used
NvRAM is faulty.
•
Re-configure using the
Setup menu.
•
Replace the PCI module
board.
0252 Password checksum bad -
Password cleared
NvRAM is faulty.
•
Re-set the password in the
Setup menu.
•
Replace the PCI module
board.
0260 System Timer Error
CPU module board is faulty.
•
Replace the CPU module
board.
0270 Real Time Clock Error Real-time clock error
•
Replace the CPU module
board.
0271 Check date and time setting Real-time clock is set
incorrectly.
•
Set the correct date and
time in Setup menu.
•
Replace the PCI module
board.
0280 Previous boot incomplete -
Default configuration used
Configuration error in Setup
menu.
•
Check configuration in
Setup menu.
02B0 Diskette drive A error Floppy drive A is faulty.
•
Replace the floppy disk
drive A.
02B2 Incorrect Drive A type - run
SETUP
Configuration error in Setup
menu.
Specify the correct drive type
in Setup menu.
02D0
System cache error - Cache
disabled
•
CPU is faulty.
•
CPU module board is
faulty.
•
Replace the CPU.
•
Replace the CPU module
board.
0B1B PCI System Error on
Bus/Device/Function
PCI device is faulty.
0B1C PCI Parity Error on
Bus/Device/Function
PCI device is faulty.
•
Replace the PCI device
board.
•
Re-install the PCI device
board.
•
Re-configure the PCI
board.