NEC FD1165 - Chapter 2 Installation and Operation; 2.1 Preliminary Inspection; 2.2 Unpacking and Repacking

CHAPTER 2
INSTALLATION AND OPERATION
This ch~pter gives unpacking and installation information
and operating instructions for the ModelFDl165 Flexible
Disk Drive.
2.1 PRELIMINARY INSPECTION
Before you unpack the Model FDl165, inspect the shipping
carton for damage. If there is damage, notify the carr ier
immediately. Do not open the carton' until the representa-
tiveof 'the carrier inspects it. If the carton is undam-
aged, unpack the disk drive by following the unpacking
instructions (see Section 2.2~1).
2.2 UNPACKING AND REPACKING
This section describes unpacking and repacking the Model
FDl165.
2.2.1 Unpacking Procedure
To unpack the Model FDl165, refer to Figure 2-1 and use the
following procedure.' Save all shipping rna ter ialsfor pos-
sible use in reshipment. .
a. Remove the tape band from around the shipping pack-
age. '
b. Slide the styrofoam case out of the cardboard
sleeve.
c. Open the styrofo~m case.
d. Remove the plastic film cover from the disk drive.
e. Insp~ct, the disk drive for any shipment damage.
2.2.2 Repacking Procedure
To repack the Model FDl165 for reshipment, reverse t~e pro-
cedure in Section 2.2.1.