NEC FD1165 - Adjusting the Door Lock Solenoid

To replace the door lock solenoid, reverse the removal pro-
cedure, then do the following.
a. Lock the door and acti vate the solenoid by pushing
in at the end of the solenoid that is opposite the
shaft.
b. Make sure that the clearance between the solenoid
shaft and the lock lever is 0.02 +.006 inches (0.5
± 0.15 rom) (see Figure 4-2.0A). - To adjust this
value, loosen the screws that fasten the door handle
to the handle plate, then move the handle to change
the pos i tion of the lock lever, and tigh ten the
screws.
If even greater adjustment is needed loosen screws
A and B (see Figure 4-19), move the door lock sole-
noid, and tighten the screws.
b. Make sure that the lock pin protrudes beyond the
lock le'ler 0.06 +.006 inches (1.5 rom +0.15 rom) (see
Figure 4-20B). Adjust this value by moving the door
handle.
c. Wi th th,e solenoid acti vated the clearance from the
edge of the lock lever to the tip of the shaft of
th e so 1 eno i dis O. 03 + •006 inc h es (0 •7 rom + O. 15
mm) (see Figure 4-20B)~
LOCK
LEVER
A
SOLENOID r- + .
SHAFT ----JiIoo" 0.02-.006 m.
'" -----I r (0.5 0.15 mm)
B _~ ~ B O.28±'006 In.
j ~LOCK 1O.70.15mmJ
0.06±.006 in.
(1.5 0.15 mm)
LEVER
Figure 4-20 Adjusting the Door Lock Solenoid
4-21