26
Setting Illumination Pattern for Call
Indicator Lamp
The following explains how to set the illumination
pattern (color of Call Indicator Lamp).
(1) Display the Menu screen, and select “Settings”
(2) Select 1 (User Setting).
(3) Select 1 (Incoming Call).
(4) Select 4 (Illumination).
(5) Select 1 (External Call) or 2 (Internal Call).
(6) Select a desired illumination pattern.
Enabling/Disabling RTP Alarm
The following procedure explains how to enable/
disable RTP Alarm. The RTP Alarm tone allows the
terminal user to be notified that the voice packet is not
received in a certain period of time because of the
network delay, etc.
(1) Display the Menu screen and select Settings.
(2) Select 1 (User Setting).
(3) Select 2 (Talk).
(4) Select 1 (RTP Alarm).
(5) Select whether to ring the RTP Alarm.
Enabling/Disabling DTMF Tone
The following procedure explains how to set whether a
DTMF tone is played when the other party presses a
button on their telephone during a call.
(1) Display the Menu screen and select Settings.
(2) Select 1 (User Setting).
(3) Select 2 (Talk).
(4) Select 2 (DTMF Tone).
(5) Select whether the DTMF tone is played.
Tone Type 1 to Tone Type 8:
In the preview function, each ringer tone
sounds continuously. However when 0
(Automatic) is selected, each ringer pattern of
internal and external incoming calls is
determined by the initial system settings.
For details, contact the system administrator.
When selecting Automatic, the preview
function does not operate.
Setting by Feature key it becomes effective.
The Music Ring 1/2/3 have been downloaded
at factory to terminal firmware 2.1.0.0 or later.
When you use ring tone music source other
than Music Ring 1/2/3, please download the
other music file.
If the 0 (Automatic) is selected, this feature is
activated in accordance with the system data
setting. If it is not specified by the system data
this feature is in effect (RTP Alarm = ON).
For details, contact the system administrator.
To Next Page
Loading...
Need help?
General