NEC M230X - Turning on the Projector

16
2. Projecting an Image (Basic Operation)
Standby Blinking PowerOn
Steady orange light Blinking blue light Steady blue light
 Turning on the Projector
1. Uncover the lens by sliding the lens cover (M350X/
M300X/M260X/M230X/M300W/M260W/M420X/M420XV)
orremovingthelenscap(M350XS/M300XS/M260XS/
M300WS/M260WS)
 [M350XS/M300XS/M260XS/M300WS/M260WS]
• Do not removethe lens cap by pulling on the string.
Doing so can cause mechanical damage to the part
around the lens.
2. Pressthe (POWER)buttonontheprojectorcabinet
orthePOWERONbuttonontheremotecontrol.
The POWER indicator will turn to blue and the projector
will become ready to use.
TIP:
• Whenthemessage“Projectorislocked!Enteryourpassword.”
isdisplayed,itmeansthatthe[SECURITY]featureisturnedon.
(→page32)
After you turn on your projector, ensure that the computer
or video source is turned on and that the lens cover is
open.
NOTE:Whennoinputsignalispresent,theno-signalguidanceis
displayed(factorymenusetting).
(→page127)
Lens cover
Lens cap