5-47
11. Auto Adjustment Signal: No. 3 (VGA480) All White
Signal: No. 23 (1600*1200@85Hz) All White
When this adjustment is done, picture size, linearity, picture position, picture deformation, video adjustment
are to be finished.
1) Receive signal 3 (VGA480) All White, and confirm that the picture size and picture position is as follows.
Open Menu (S), TAG D "AUTO ADJUT L", and push "Proceed" SW (Adjustment data is written in the
Monitor at this time).
2) Receive signal 23 (1600*1200@85Hz) All White, and confirm that the picture size and picture position is as
follows.
Open Menu (S), TAG D "AUTO ADJUT H", and push "Proceed" SW (Adjustment data is written in the
Monitor at this time).
Picture size H: 396±1mm
V: 297±1mm
Picture position H: | Xleft - Xright | ≤ 1.0mm
V: | Xtop - Xbottom | ≤ 1.0mm
12. Factory settings for shipping
1) Open MENU(S) ,TAG D), and “destination” set following
A Ver :USA
B Ver :EUR
2) OPEN MENU(S) ,TAG D), and “HOURS READ” set “NO”.
Press “EXIT” switch two times.
3) Make sure that the LED is Green when the unit receive Signal (Make sure that come out of the MENU(S))
4) Open MENU(U) ,TAG5) "TOOL1”, and move highlighted bar to "FACTORY PRESET" and press the
RESET switch. Then press the PROCEED switch.
5) OSM
Open MENU(U) and make sure that the display of the third item is as follows.
TOOL2-LANGUAGE : ENGLISH
TOOL2-IPM :“IPM OFF MODE” ENABLE
TOOL2-EDGE LOCK :”1”
6) BNC/D-SUB switch : D-SUB
7) POWER switch : OFF
To Next Page
Loading...
