Chapter 7 Dterm IP Dterm IP Setup
NEAX 2000 IPS Configuration Guide
NDA-24347, Issue 1
Page 75
Note 1: To operate the Dterm IP normally, you must not change the port number,
which has been set except when the port number needs to be changed.
Note 2: For the port number of the DRS System-based, ask the NEAX 2000 IPS
maintenance person.
STEP 10: After setting on the Administrator Menu, while displaying that menu, press
Exit key (Softkey).
The User Menu appears on the LCD.
STEP 11: Press Save key (Softkey).
The data is saved and Dterm IP is reset. The LCD returns to normal
condition.
END OF SETUP
5. RTP
Self-port
XXXXX
Enter the Real-time
Transfer Protocol (RTP)
Self-port number.
Note 1
6. Voice Ctrl
Self-port
XXXXX
Enter the Voice Control
Self-port number.
Note 1
6 Download
1: Program (TFTP)
2: Program (FTP)
3: Config (TFTP)
4: Config (FTP)
5: Program and Config
(TFTP)
6: Program and Config
(FTP)
Select the items 1-6 for
downloading the program
on the Dterm IP and Dterm
IP Configuration files.
7 Soft Reset -
Select for resetting the
Dterm IP software.
8 Factory Value - No setting is required.
Table 7-2 Administrator Menu Items (Continued)
MENU
NO.
INDICATION SETTING DATA DESCRIPTION
To Next Page
Loading...
