NEC NP-PH3501QL - Page 44

27
2. Projecting an Image (Basic Operation)
Selecting Default Source
You can set a source as the default source so that it will be displayed each time the projector is turned on.
1. PresstheMENUbutton.
The menu will be displayed.
2. Press the ▶buttontoselect[SETUP]andpressthe▼buttonortheENTERbuttontoselect[MENU(1)].
3. Press the ▶buttontoselect[SOURCEOPTIONS(1)].
4. Press the ▼buttontoselect[DEFAULTINPUTSELECT]andpresstheENTERbutton.
 The[DEFAULTINPUTSELECT]screenwillbedisplayed.
(→ page 112)
5. Selectasourceasthedefaultsource,andpresstheENTERbutton.
6. PresstheEXITbuttonthreetimestoclosethemenu.
7. Restart the projector.
The source you selected in step 5 will be projected.
NOTE:Evenwhen[AUTO]isturnedon,the[HDBaseT]willnotbeautomaticallyselected.Tosetyournetworkasthedefaultsource,
select[HDBaseT].
TIP:
• WhentheprojectorisinStandbymode,applyingacomputersignalfromacomputerwillpowerontheprojectorandsimultane-
ouslyprojectthecomputer’simage.
 ([AUTOPOWERONSELECT]→page114)