To Next Page

To Previous Page

1. Introduction

Removing and Attaching the Cable Cover

Afternishingconnections,attachthesuppliedcablecovertoproperlyhidethecables.

CAUTION:

• Besuretotightenthescrewsafterattachingthecablecover.Failuretodosomaycausethecablecovertocome

offandfall,resultingininjuryordamagetothecablecover.

• Donotputbundledcablesinthecablecover.Doingsomaydamagethepowercord,resultinginare.

• Donotholdthecablecoverwhilemovingtheprojectorordonotapplyexcessiveforcetothecablecover.Doingso

maydamagethecablecover,resultingininjury.

Removingthecablecover

Toolneeded:

• Phillipsscrewdriver(plus-head)about9cm/4inchesinlength

9 cm/4 inches

1. Loosen the cable cover screws until the Phillips screw-

driver goes into a freewheeling condition

2. Remove the cable cover.

1Push up the cable cover slightly and rotate it to release.

Pull the cable cover while pushing and holding the arrow

part

 Ifyoundittohardtoreleasethecablecover,tryholdingit

slightly up.

NEC NP-UM330X User Manual

Other manuals for NEC NP-UM330X