NEC NP-UM330X User Manual

66
4. Using the Viewer
Removing the USB memory from the projector
1. SelecttheVIEWERstartscreen.
 PresstheEXITbuttonwithnomenudisplayed.
2. RemovetheUSBmemoryfromtheprojector.
 MakesurethattheLEDontheUSBmemoryisnotashing
before removing the USB memory.
NOTE:IfyouremovetheUSBmemoryfromtheprojectorwithaslide
displayed,theprojectormaynotoperatecorrectly.Ifthishappens,
turnofftheprojectorandunplugthepowercord.Wait3minutes,then
connectthepowercord,andturnontheprojector.
Exiting the Viewer
1. Press the MENU button with the slide screen or the
thumbnail screen displayed.
The control bar or the pop-up menu will be displayed.
2. Press the MENU button again.
The on-screen menu will be displayed.
3. Select a source other than [VIEWER] and press the
ENTER button.
The Viewer will be exited.
TIP:ToexittheViewerusingtheremotecontrol,selectasourceother
than[VIEWER].

NEC NP-UM330X Specifications

General

Brand	NEC
Model	NP-UM330X
Category	Projector
Language	English