NEC NP-UM330X - Projecting images stored in a USB memory device

64
4. Using the Viewer
❷ Projecting images stored in a USB memory device
ThissectionexplainsthebasicoperationoftheViewer.
TheexplanationprovidestheoperationalprocedurewhentheViewertoolbar(→page68)issettothefactoryde-
fault.
-StartingtheViewer .......................................................................below
-RemovingtheUSBmemoryfromtheprojector ....................... page66
-ExitingtheViewer..................................................................... page66
Preparation:BeforestartingtheViewer,storeimagestotheUSBmemoryusingyourcomputer.
Starting the Viewer
1. Turnontheprojector.(→ page 16)
2. InserttheUSBmemoryintotheUSBportoftheprojec-
tor.
• DonotremovetheUSBmemoryfromtheprojectorwhile
it’s LED flashes. Doing so may corrupt the data.
3. PresstheSOURCEbuttonontheprojectorcabinet.
The Viewer start screen will be displayed.
• PresstheVIEWERbuttonontheremotecontrol.