NEC NP43 - Setting the Default Source

19
3. Projecting an Image (Basic Operation)
Selecting Default Source
Youcansetasourceasthedefaultsourcesothatthedefaultsourcewillbedisplayedeachtimetheprojectoris
turnedon.
1. Press the MENU button.
The menu will be displayed.
2. Press the ▶ button twice to select [SETUP] and press
the ▼ button or the ENTER button to select [GENERAL].
3. Press the ▶ button three times to select [OPTIONS(2)].
4. Press the ▼ button six times to select [DEFAULT
SOURCE SELECT] and press the ENTER button.
The [DEFAULT SOURCE SELECT] screen will be dis-
played.
(→ page 74)
5. Select a source as the default source, and press the
ENTER button.
NOTE: To specify[VIEWER]as thedefaultsourceon theNP64
orNP54,select[VIEWER]fromthe[DEFAULTSOURCESELECT]
screen,andpresstheENTERbuttonbecausedetectingthesignal
automaticallyisnotavailablefortheViewersourceontheNP64
andNP54.
6. Press the EXIT button a few times to close the menu.
7. Restart the projector.
The source you selected in step 5 will be displayed.
TIP:Whentheprojectorisin Standby mode,applyingacomputer
signalfromacomputerconnectedto theCOMPUTERINinputwill
power ontheprojectorandsimultaneously projectthecomputer’s
image.
([AUTOPOWERON(COMP.)]→page73)
NP63/NP43
NP64/NP54