NEC PA903X - Using The Lens Memory Function [Lens Memory]

99
5. Using On-Screen Menu
Using the Lens Memory Function [LENS MEMORY]
ThisfunctionservestostoretheadjustedvaluesforeachinputsignalwhenusingtheLENSSHIFT,ZOOMandFO-
CUSbuttonsoftheprojector.Adjustedvaluescanbeappliedtothesignalyouselected.Thiswilleliminatetheneed
toadjustlensshift,focus,andzoomatthetimeofsourceselection.
STORE ������������������� Stores the current adjusted values in memory for each input signal�
MOVE �������������������� Applies the adjusted values to the current signal�
RESET �������������������� Returns the adjusted values to the last condition�
• ThelensunitsNP11FL,NP12ZL,NP13ZL,NP14ZL,andNP30ZLdonotsupportthisfunction.
NOTE:
• LensmemoryadjustmentswillbeautomaticallyregisteredtheENTRYLIST.Theselensmemoryadjustmentscanbeloadedfrom
theENTRYLIST.(→ page 85)
 Notethatperforming[CUT]or[ALLDELETE]intheENTRYLISTwilldeletelensmemoryadjustmentsaswellassourceadjust-
ments. This deletion will not take effect until other adjustments is loaded.
• Forstoringeachadjustmentoflensshift,motorizedzoomandmotorizedfocusascommonvalueforallinputsignal,storethem
as reference lens memory.
Tostoreyouradjustedvaluesin[LENSMEMORY]:
1. Projecttheconnecteddevicesignalyouwanttoadjust.
2. Adjusttheprojectingimageofposition,sizeandfocusbytheLENSSHIFT/HOMEPOSITION,ZOOM+/−,and
FOCUS+/−buttons.
• Adjustmentcanbeperformedbytheremotecontrol.Pleasereferto“AdjustingthePictureSizeandPosition”
on page 21.
• Slightadjustmentbymovingtheprojectorpositionandbythetiltfootisnotsubjectof[LENSMEMORY].
3.Movethecursoron[STORE]andpressENTER.
4.Movethecursoron[YES]andpressENTER.