NEC PA903X - ❷ Shift The On-Screen Menu Displaying Position

34
❷ Shift the On-Screen Menu displaying position
1. Press the MENU button.
The On-Screen Menu will be displayed on.
2. Move the cursor by the ▶buttontothe[SETUP]andthenpresstheENTERbutton.
The cursor will move to the [MENU1].
3. Move the cursor by the ▶buttontothe[MENU2].
4. Move the cursor by the ▼buttontothe[MENUPOSITION]andthenpresstheENTER.
The On-Screen Menu will go into the MENU POSITION setup screen.
5. MovethecursoreitherTO[HORIZONTALPOSITION]or[VERTICALPOSITION]bypressing▼ or ▲ button
and then press ◀/▶
buttontoshifttheOn-ScreenMenu.
For finishing the setting on the On-Screen Menu, press the MENU button on the remote control.
TIP:
• Oncetheprojectorispoweredoff,theOn-ScreenMenudisplayingpositionwillberesettothedefaultfactorysettingposition.
• Thisfunctiondoesnotinuencetothedisplaypositionofinputterminalinformationandmessage.
• ItenablestomovethemenubymouseclickwhenacommerciallyavailableUSBmouseisconnected.
• Itenablestomovethemenupositionbythe▼▲◀ and ▶buttonsholdingtopresstheCTLbuttonontheremotecontrolor
mouse click.
• WhiletheMENUPOSITIONoftheon-screenmenuisdisplayedonandthemenuismovedbythe▼▲◀ and ▶ buttons holding
topresstheCTLbuttonontheremotecontrol,theindicationofadjustedvalueonthemenuwillnotbechanged.Inthiscase,
closetheMENUPOSITIONmenuonceanddisplayitagainforindicatingtheadjustedvalueproperly.