NEC PA903X - Adjusting The Vertical Position Of A Projected Image (Lens Shift)

22
2. Projecting an Image (Basic Operation)
Adjusting the vertical position of a projected image (Lens shift)
CAUTION
• Performtheadjustmentfrombehindorfromthesideoftheprojector.Adjustingfromthefrontcouldexposeyour
eyestostronglightwhichcouldinjurethem.
• Keephandsawayfromthelensmountingportionwhileperformingalensshift.Failuretodosocouldresultin
ngersbeingpinchedbythemovinglens.
1. PresseitherSHIFT/HOMEPOSITIONbuttononthecabinetorLENS
SHIFTBUTTONontheremotecontrol.
The [LENS SHIFT] screen will be displayed.
2. Press the ▼▲◀▶buttonstomovetheprojectedimage.
• Tosetbackthelenstothehomeposition
Press and hold the SHIFT/HOME POSITION button over 2 seconds. The lens mounted on the projector goes
back to the home position. (roughly to the center position)
NOTE:
• Ifthelensisshiftedtothemaximuminthediagonaldirection,thescreenperipheralareawillbedarkorshaded.
• UseNP11FLatthehomeposition.