CHAPTER 5 FEATURE DESCRIPTION
UNIVERGE NEAX 2000 IPS General Description Page 107
Issue 5
Automatic Wake-up
This feature allows the system to be programmed to automatically call guest rooms or
administration stations at specified times. Upon answering, the guest is connected to a recorded
announcement or music source. A printout of unanswered or blocked Automatic Wake-Up
attempts for each guest room is provided using the Hotel/Motel printer.
Background Music
Background Music can be provided on a dial-up basis over legacy Multiline Terminal speakers.
Incoming voice announcements, ringing and recalls override Background Music. Up to 10 music
programs can be offered.
Back Up CPU
UNIVERGE
NEAX
2000 IPS provides a dual CPU system with two MP cards. When Emergency
Notification from hardware is detected, the changeover from an active MP card to a standby MP
card will occur. If the active MP card becomes out of order for any reason, the standby MP card
starts up automatically. The standby MP card employs a Cold Standby System that will restart
initialization by the changeover from the active MP card.
Bandwidth Control
This feature allows assigning an available bandwidth threshold for VoIP Traffic within a
location and between locations, and to restrict Outgoing/Incoming Calls when the VoIP Traffic
exceeds the threshold. The location is a group of VoIP devices [IP Enabled Dterm, IP PAD, or
Peer-to-Peer IP Trunks (built-in IP Trunks)], that have the same VoIP communication parameter
(such as CODEC Selection List and ToS field) values assigned. When the VoIP Traffic over
CCIS exceeds the threshold, the call can be routed to Legacy Trunks (TDM Network). When
exceeding the threshold, the system can store fault information and provide external alarm
indication.
Boss / Secretary Calling
A secretary with a Multiline Terminal can use an appearance of the boss' extension to screen
calls for that extension, and announce and/or transfer calls to that extension. Additionally, the
secretary can call the boss during a busy condition and send a Message Waiting Indication to the
boss' station.
Broker's Call
This feature allows a Multiline Terminal or Single Line Telephone user to alternate between two
parties, talking to one party while the other party remains on Hold on the same line. The
Multiline Terminal user uses the TRF or ANS key to alternate between the two parties. The
Single Line Telephone user uses the Hold feature to alternate between the two parties.
Call Back
This feature allows a calling party to set an automatic Call Back when a busy or no answer
condition is encountered. When the busy station becomes idle, the station that set the Call Back
will be called. In case of Call Back no answer, the Call Back to the setting station is initiated
immediately after the called station goes on hook after making a call or accessing a feature.
To Next Page
Loading...
