CHAPTER 5 FEATURE DESCRIPTION
UNIVERGE NEAX 2000 IPS General Description Page 130
Issue 5
Station Hunting - Circular
When a busy station in a hunt group is called, this feature permits the call to be processed
automatically through the hunt group in a preprogrammed order from that station's position
within the hunt group.
Station Hunting - Terminal
When a pilot number is dialed and that number is busy, sequential Station Hunting will be
initiated. However, if a number other than the pilot number is dialed and that number is
busy, busy tone will be provided rather than initiate Station Hunting.
Station Hunting - Secretarial
This feature allows assignments to be given to members of Terminal and Circular Hunting
groups to reroute calls (when their hunting group is all busy) to a back-up hunting group.
Station Message Detail Recording (SMDR)
This feature provides a call record for outgoing station-to-trunk calls and incoming trunk-to-
station calls (including Data Call). This facilitates cost control by identifying trunk use and
misuse by individual stations. Station Message Detail Recording (SMDR) enables call billing to
customers and clients, and provides a means for checking local telephone bills.
Station to Station SMDR
Based on the existing feature of SMDR output, this feature enables the output of an SMDR
record for station-to-station calls (two-station connection). This output is based on the
NEAX 2400 SMDR Format and can be interfaced from the MP via RS232C, MP via
TCP/IP or AP00B MRC-F via RS232C. This feature can be enabled for SLT, Dterm, Dterm
IP, PS, or Softphone.
Station Service Status Display
This feature provides a maintenance person to know a service feature setting status for a specific
station at a glance. By entering single command, the maintenance person can see a list of service
features/station status regarding to the specific station.
Station Speed Dialing
This feature allows a station user to dial frequently called numbers by dialing an access code and
an abbreviated code, or by depressing a feature key or line key assigned for Station Speed
Dialing capability.
Step Call
This feature allows the Attendant or station user, after calling a busy station, to call an idle
station by simply dialing an additional digit. This feature will operate only if the number of the
idle station is identical to that of the busy station in all respects, except the last digit.
Supervisory Control of Peripheral Equipment
When various types of peripheral equipment (such as facsimiles, dictation equipment, Voice
Mail, etc.) are connected to the line circuits of the UNIVERGE
NEAX
2000 IPS, this feature
allows the loop of the line circuit concerned to open for a programmable interval, and send a
release signal to the peripheral equipment when the calling party disconnects.
System Clock Setup by Station Dialing
This feature enables a Station User to set up the System Clock, from Single Line Telephone,
Multi-line Terminal, and PS.
To Next Page
Loading...
