CHAPTER 5 FEATURE DESCRIPTION
UNIVERGE NEAX 2000 IPS General Description Page 131
Issue 5
System Speed Dialing
This feature provides all users the ability to dial frequently called numbers using an abbreviated
call code.
Tenant Service
This feature provides for more than one organization (tenant) to share the same UNIVERGE
NEAX
2000 IPS system. Through system programming, each organization may be restricted to its
own Central Office trunks, Attendant Consoles and extension group. In addition, incoming calls
are directed to the specific tenant.
Terminal Login via NAT
The UNIVERGE
NEAX
2000 IPS supports network configuration via a router with NAT. NAT
(Network Address Translation) is a technology that translates an internal local IP address to a
globally unique IP address before sending packets to the outside network. NAT is configured on
the router at the border of the inside network and the outside network. NAT is used for efficient
use of global IP addresses and for security (shield internal addresses from the public Internet).
•
Remote connections of IP Enabled Dterm via NAT
- Provide communications between IP Enabled Dterm located under the same NAT.
- Provide communications between IP Enabled Dterm located under different NAT.
Tie Lines
This feature allows any station user dial access or direct access to an E&M Tie Line.
Tie Line Tandem Switching
This feature allows trunk-to-trunk connections through the UNIVERGE NEAX 2000 IPS without
the need for any Attendant assistance or control. The major use of this feature is in association
with a dial tandem tie line network to allow tie line connections and incoming tie line calls
automatic access to, and completion of, local Central Office calls.
Timed Forced Release
This feature allows the system to restrict a long-time call to reduce phone rates for trunk calls.
For an outgoing trunk call, an incoming trunk call and a tandem call, when the preset time
elapsed, the call is released forcibly.
Timed Queue
When a user originates an outgoing trunk call and the called party is busy or does not answer, the
caller can set the Timed Queue feature. When this feature is set, the trunk seizure is repeated and
the number is redialed after a predetermined time interval.
Timed Reminder
This feature allows the system to be programmed to automatically call stations at specified
times. Upon answering, the station is connected to a recorded announcement or music source.
Trunk - Direct Appearances
This feature allows Multiline Terminal users the ability to access a CO line or E&M Tie Line
without dialing an access code. For this feature, trunks must be assigned to the line keys on the
Multiline Terminal. Incoming calls on CO lines can be answered on the appropriate trunk line
appearance.
To Next Page
Loading...
