CHAPTER 7 SPECIFICATIONS
UNIVERGE NEAX 2000 IPS General Description Page 162
Issue 5
Common Control Cards
Name Code Remarks
PN-CP24-D
Main Processor Card for UNIVERGE
NEAX 2000 IPS.
One card is required per system.
PN-CP27-B
Main Processor Card for UNIVERGE
NEAX 2000 IPS Dual MP System.
One card is required per system.
PN-CP31-E
Main Processor Card for UNIVERGE
NEAX
2000 IPS
DML.
One card is required per system.
PN-CP31-D
Main Processor Card for
UNIVERGE
NEAX 2000 IPS
DMR.
One card is required for each Remote Site.
PZ-M606A
(for IPS and
DMR)
Ethernet Control Card:
• Mounted on MP card to accommodate the Ethernet and
transmit/receive a signal of TCP/IP protocol.
• 10 BASE-T/100 BASE-TX twisted pair cable is connected directly to
this card.
PZ-M697
(for DML)
Ethernet Control and inter-module BUS interface Card:
•
Mounted on PN-CP31-E card to accommodate the Ethernet and
transmit/receive a signal of TCP/IP protocol.
•
10BASE-T/100BASE-TX twisted pair cable is connected directly to this
card.
• BUS interface functions as a driver/receiver of various signals, adjusts
gate delay timing and cable delay timing, monitors I/O Bus and PCM BUS.
•
Occupies two physical slots width per card on PN-CP31-E card.
PN-CP15
(for IPS)
Firmware Processor Card:
Provides Line/Trunk interface, Memory (RAM 768 KB), and inter-module
BUS interface. BUS interface functions as a driver/receiver of various
signals, adjusts gate delay timing and cable delay timing, monitors I/O Bus
and PCM BUS. When the system consists of three PIMs or more, one each
of this card is mounted respectively in PIM2, PIM4, and PIM6.
PN-CP33
(for DML)
Firmware Processor Card
Provides Line/Trunk interface, Memory (RAM 768 KB), and inter-module
BUS interface. BUS interface functions as a driver/receiver of various
signals, adjusts gate delay timing and cable delay timing, monitors I/O Bus
and PCM BUS. When the system consists of three MCs or more, one each
of this card is mounted respectively in the MP slot of MC2, MC4, and MC6.
To Next Page
Loading...
