CHAPTER 7 SPECIFICATIONS
UNIVERGE NEAX 2000 IPS General Description Page 163
Issue 5
Major specifications and functionality of the UNIVERGE NEAX IPS MPs are shown below:
Item
PN-CP24-D
PN-CP27-B
Central Processing ElanSC520
System Memory CP24D: Flash ROM (16MB), SDRAM (64MB)
CP27B: Flash ROM (8MB), SDRAM (32MB)
Network Switching
1,024 · 1,024 Time Division Switch
(Note 1)
3-Way Conference 16 sets of 3-way conference circuitry
DTMF Signal Sender 32 circuits (digit 0 to 9, *, and # are generated)
Music-on-Hold 10 types are available
(Note 2)
Mini Jack 1 for External Music Source for MOH (Note 2)
Audible Tone Generator (DTG) Available
Phase Lock Oscillator (PLO) 2 ports (Source/Receiver)
Built-in SMDR Available
Built-in MCI Available
Built0in PMS Available
Built-in FP0 Available
BS00 Function Available
DTMF Receiver 4 circuits
AP01 Function Available
Built-in DRS Available
Virtual IPT / Virtual CSH Available
System data copy from active MP to standby MP CP27B (Dual MP) only
MP Program Download (FTP) Available with CP24D only (Note 3)
Direct Connection 1 port
Remote Connection w/Built-in MODEM 1 port (Note 4)
MAT
Interfac
e
LAN Connection Available
External Alarm Indication MJ and MN
DAT 2circuits (120 seconds per circuit)
DK00 2 circuits (relay drive x1, external key scan x1)
Application Key Program In EPROM
Note 1: Refer to the Figure 4-2 on next page for the port allocation of the Time Division Switch.
Note 2:
In case of Dterm IP, the synthesized melody is provided built in to IP adapter.
Note 3:
MP Program Download (FTP) is for Stand Alone Systems Only (CP24D.)
Note 4: No. 1 Port includes a built-in modem for a remote connection of the MAT.
To Next Page
Loading...
