NEC Univerge SV8100 - Page 129

UNIVERGE SV8100 Issue 4.0
ACD Installation Manual 3 - 97
Operation
Logging on as the ACD System Supervisor
To log on as the ACD System Supervisor:
You only have System Supervisor capability while logged on.
1. Press the Speaker key.
2. Dial
5.
 You hear confirmation tone.
- OR -
Press ACD Log On/Off key (Program 15-07-01 or SC 752: code *10).
 Your Log On/Off key lights and you hear a single beep.
 Your display will show: SUPERVISOR.
Logging off as the ACD System Supervisor
To log off as the ACD System Supervisor:
This will end your System Supervisor capabilities. Your Log On/Off key is lit and your
display shows: SUPERVISOR
1. Press the Speaker key.
2. Dial
5.
- OR -
Press ACD Log On/Off key (Program 15-07-01 or SC 752: code *10).
 Your display shows: ACD LOGOUT (1:Yes, 0:No)
3. Dial 1 to log out.
 You hear confirmation tone (if you dialed *5) or a single beep (if you pressed the ACD
Log On/Log Off key) and the Log On/Off key goes out.
 Dial 0 instead to cancel the log out.
Taking all the ACD Groups Simultaneously Out Of Service
To take all your ACD Groups out of service:
You must be logged on as the ACD System Supervisor.
1. Press your Out of Service key (Program 15-07-01 or SC 752: code *14).
 Your display shows: END OF WORK? (1:Yes,0:No)