Issue 4.0 UNIVERGE SV8100
3 - 52
Programming
15-02-02 Multiline Telephone Basic Data Setup – Trunk Ring Tone
For the SIE key ring tone range assigned in Program 15-08-01 below,
choose the extension’s desired ring tone (pitch) within the range selected.
The choices are 1 (high), 2 (mid range), 3 (low), or 4~8 (Ring Tones 1~5).
This also affects how certain trunk calls (such as DILs) ring the extension.
15-07-01 Programmable Function Keys
Assign function keys for ACD SIE (code *03 + ACD Group master number).
15-08-01 Incoming Virtual Extension Ring Tone Setup
Assign a ring tone range (0~4) to each extension. When a SIE key rings, it
uses the range assigned in this option. The choices are 0 (tone pattern 1), 1
(tone pattern 2), 2 (tone pattern 3), 3 (tone pattern 4) and 4 (extension ring
tone). The ring the user hears also depends on the setting of Program
15-02-02 above and Service Code 720.
15-09-01 Virtual Extension Ring Assignment
Individually program an extension's SIE keys to either ring (1) or
not ring (0).
15-10-01 Incoming Virtual Extension Ring Tone Order Setup
Set the priority (1~4) for the ring tone ranges set in program 15-08-01
below. When more than one SIE key rings simultaneously, the tone with the
highest priority (e.g., 1) rings. The other keys just flash.
15-11-01 Virtual Extension Delayed Ring Assignment
Individually program an extension’s SIE keys for Delayed Ringing (1) or
Immediate Ringing (0). Also see Program 20-04-03 below.
20-04-03 System Options for Virtual Extensions – CAR/SIE/Virtual Extension
Delay Interval
SIE keys set for delayed ringing (see Program 15-11-01 below) ring the
covering extension after this interval.
22-03-01 Incoming Call Setup – Trunk Ring Tone Range
Select the ring tone range (0~8) for each trunk to ring in an ACD group. The
trunk uses a ring tone within the range selected when it rings an extension
There are four ring tones available.
Related Features
Programmable Function Keys
To Next Page
Loading...
