NEC Univerge SV8100 - Night Mode; Figure 4-9 Night Mode Screen

SV8100 Issue 1.0
Desktop Applications 4 - 9
___________________________________________________________________________________
___________________________________________________________________________________
Park orbit.
 Selecting the Cancel button will close the Unpark Call dialog without
initiating a unpark operation.
 If the Unpark operation fails because the selected Park orbit is not
occupied, an error message will be displayed.
1.11 Night Mode
The Night Mode button is used to change the system night mode setting.
When this function is selected, the following dialog will be displayed (Figure
4-9 Night Mode Screen).
The Mode options that are available are:
 Day Mode
 Night Mode
 Midnight Mode
 Rest Mode
 Day 2 Mode
 Night 2 Mode
 Midnight 2 Mode
 Rest 2 Mode
If the system programming is setup to require a password, then the user will fill
in the Password field.
Pressing the Start button will initiate the command to set the requested Night
Mode options.
Figure 4-9 Night Mode Screen