107
TO MAKE AN EXTERNAL CALL
When dialed telephone number is registered in Per-
sonal Directory, the corresponding name information
will be displayed on LCD while you are hearing a ring-
back tone or are engaged in a conversation. According
to the initial settings, the display may differ from the fol-
lowing examples. For more information, contact the
system administrator.
STEP 1: Lift the handset or press , and you will
receive a dial tone.
STEP 2: Dial the Central Office access code, e.g. 9.
STEP 3: Dial desired telephone number.
(while hearing a ringback tone)
STEP 4: Use handset or Mic to start a conversation.
Display indicates:
(while in a conversation)
• When dialed number is registered in Personal Directory
Note
This section describes the Normal Dial Mode. Regard-
ing the other mode, see
TO ORIGINATE A CALL
USING SELECTIVE DIALING (DYNAMIC DIAL
PAD, PRESET DIAL)
.
1:25 PM MON 11 MAY 2015
31313
Station Number
of My Line
Mic NoDist >>>
1:25 PM MON 11 MAY 2015
9
Dialed Code
Mic Pickup CF-All >>>
Note
In the above case, a maximum of eight digits of the
number (including “*”) can be displayed. If the dialed
number exceeds eight digits, “the first seven digits of
the number + *” or “the last seven digits of the number +
*” are displayed. For more information, contact the sys-
tem administrator.
1:25 PM MON 11 MAY 2015
9XXXXXXXXX
Dialed Code + Number
Mic Pickup CF-All >>>
9XXXXXX*
00:05
Elapsed Time
TOM JONES
Mic NoDist >>>
Dialed Code
Name Information
registered in
Personal Directory
+ Number
To Next Page
Loading...
