243
To Adjust the Ringer Tone Volume in Idle
Status
STEP 1: Press the Headset key while in idle status to
switch from headset mode to handset mode,
and the Headset key lamp turns off.
STEP 2: Receives a call from another line.
STEP 3: Press Up/Down ( ) key while a ringer tone
is on.
For Ringer Tone Volume in Busy Status
If other lines are accommodated in the tele-
phone as a subline, the ring tone volume of a
subline call received while being in the middle
of a call through the headset will be lower than
usual.
HOW TO USE THE WIRELESS
HEADSET
When using Wireless Headset (WT100-EHS-NE
(manufactured by Plantronics)), you can answer a call,
have a conversation, or disconnect the call with hook-
ing operations. This section explains the terminal oper-
ation using Wireless Headset.
To Answer a Call
STEP 1: Press the Hook key of the Wireless Headset
while the ringing tone is on, and the Hook key
lights red. Depending on the setting at the in-
stallation stage, you can answer the call by
pressing key instead of Hook key.
STEP 2: Press Hook key to end the call, and the Hook
key turns off.
Note
When you receive another call during a call through the
headset, the ringer tone volume for other lines in head-
set mode can be set to the same level as the normal
two-way call. For details, contact the system adminis-
trator.
Note
The Hook key of Wireless Headset must be pro-
grammed in advance. For the programming of Headset
key, contact the system administrator.
Note
For details on how to connect a telephone and Wireless
Headset, see the manual attached to the Wireless
Headset.
To Next Page
Loading...
