123
STEP 3: Enter the desired phone number (up to 32
digits can be registered).
STEP 4: Press Regist key. Then, “Registration com-
plete!” is displayed for 3 seconds.
To Replace the Existing Data Assigned to
a One-Touch Speed Calling Key with New
Data Using SPD Set Key
STEP 1: Press the SPD Set.
STEP 2: Press desired One-Touch Speed Calling
key.
STEP 3: The phone number already registered is dis-
played. Press key or Edit soft key.
STEP 4: Enter desired phone number (up to 32 digits
can be registered).
STEP 5: Press Regist key. Then, “Registration com-
plete!” is displayed for 3 seconds.
Note
One-Touch Speed Calling during the registration opera-
tion. Also, pressing any other key (Exit, SPD Set, or
Cancel) cancels the setting. In that case, the terminal
operates in accordance with the pressed operation key.
Note
When you receive an incoming call on the accommo-
dated line while programming the One-Touch Speed
Calling key, you can continue with the programming
without answering the call. However, if you answer the
call, the conversation will be started and the registration
operation will be canceled.
Note
A new entry overwrites the previously saved phone
number (the existing number temporarily displays when
you try to set a new number).
08211XX
Cancel Clear Set >>>
1:25 PM MON 11 MAY 2015
SPD Set Mic NoDist
Entry is added!
1:25 PM MON 11 MAY 2015
SPD Set Mic NoDist
1:25 PM MON 11 MAY 2015
SPD Set Mic NoDist
Push Speed Calling Key
08211XX
ReRegi Edit Delete >>>
08211XX
Cancel Clear Set >>>
1:25 PM MON 11 MAY 2015
SPD Set Mic NoDist
Entry is added!
To Next Page
Loading...
