Setting Up and Using the Software 3-5
n Specify the subdirectory in which to install the
software. Press Enter or click “OK” to accept the
default subdirectory “DS4000.”
Wait while the utility copies the required software
into the specified subdirectory.
n Read the screen that lets you know about changes
made to the AUTOEXEC.BAT and CONFIG.SYS
files. Click “OK.”
n Read the screen that reminds you to install EZ-SCSI
if you install a SCSI device in the docking station.
Click “OK.”
8. Proceed as follows at the prompt:
n The Setup utility checks your system ID to determine
if you need to load the ESS audio drivers. If your
system does not require that the drivers be loaded, the
system prompts you to restart Windows. At the
prompt, click the “Restart Windows” button.
This completes software setup for your system.
If you want to load the ESS drivers for any reason,
insert audio diskette 1 into the drive. From the Win-
dows File menu, select the Run command. Enter
a:setup.exe and press Enter to load the drivers.
n If your system needs the ESS audio drivers loaded, a
dialog box informs you that Setup will now install
the Audio Drivers. Continue as follows:
At the prompt, remove the setup diskette, insert
Audio Applications diskette 1 into the drive, and
press Enter.
The first audio screen tells you to close any ap-
plications that are running. If you followed the
instructions given here, you already closed open
applications. Just click “Continue” to proceed.
To Next Page
Loading...