4-12 Adding Options
Removal
Follow these steps to remove an industry standard, 8- or 16-
bit expansion board from the docking station.
1. Prepare for board removal as follows:
n Disconnect and remove the NEC Versa from the
docking station.
n Turn off and unplug the docking station.
n Disconnect any peripheral devices connected to the
docking station.
n Remove the docking station cover. See “Cover Re-
moval” earlier in this section for information on re-
moving the cover.
n Position the docking station so you have access to the
side where the expansion slots are located.
CAUTION
Be careful not to drop anything into the docking sta-
tion. Doing so can damage the unit.
To Next Page
Loading...