Adding Options 4-15
Installing Drives in the Front Bay
Use the following procedure to install a half-height diskette,
tape, CD-ROM or hard disk drive in the front drive bay.
See “Preparing the Hard Disk Drive” later in this chapter
for hard disk drive preparation instructions.
Drive installation involves three basic procedures:
n Removing the drive cage.
n Attaching the drive(s) to the drive cage.
n Attaching power and signal cables to the drive.
n Finishing up (reinstalling the drive cage with the drive in
the docking station).
These procedures are described next.
Removing the Drive Cage
Prepare the docking station for drive installation by remov-
ing the drive cage as follows.
WARNING
Make sure docking station power is off, the NEC
Versa is not docked, peripheral devices are discon-
nected, and cables are detached from the docking
station before beginning installation procedures.
1. Remove the docking station cover as described in
“Cover Removal.”
2. Locate and remove the screws on the drive cage.
To Next Page
Loading...