4-8 Adding Options
Expansion slot locations
Installation
Follow these steps to install an industry standard, 8- or 16-
bit expansion board in the docking station.
1. Prepare for board installation as follows:
n Disconnect and remove the NEC Versa from the
docking station.
n Turn off and unplug the docking station.
n Disconnect any peripheral devices connected to the
docking station.
n Remove the docking station cover. See “Cover Re-
moval” earlier in this section for information on re-
moving the cover.
n Position the docking station so you have access to the
side where the expansion slots are located.
To Next Page
Loading...