Setting Up and Using the Software 3-7
Docking Station 4000 Setup Software
This section describes how to use the software that the
Docking Station 4000 Setup utility loads in your NEC
Versa.
n At start up, the NEC Versa lets you choose a configura-
tion to use. See “Choosing a Configuration” for infor-
mation.
n NEC Versa M users can use either the Docking Sta-
tion 4000 sound system or the NEC Versa sound sys-
tem. See “Using the Audio Switcher Utility” for more
information.
n Some programs run from MS-DOS instead of Windows.
Use the information under “Using DOS-Based
Programs” to enable and control Docking Station 4000
sound from MS-DOS applications.
Choosing a Configuration
After setting up the Docking Station 4000 software, your
NEC Versa boot-up differs from its original procedure. The
new boot up sequence lets you choose which configuration
to use.
Use the new boot up procedure as follows:
1. Power on your NEC Versa as you would normally. A
menu similar to the following is displayed.
1. Docking Station 4000 Configuration
2. Mobile Configuration
3. Docked Configuration
To Next Page
Loading...