3-4 Setting Up and Using the Software
Running the Setup Utility
This section describes how to use the Docking Station 4000
Setup utility. While running the utility, you can use the fol-
lowing options:
n To stop the installation, press Esc.
n To accept default settings, press Enter, click “OK,” or
click “Continue” at the prompts.
n To change settings, follow the on-screen instructions.
Run the Docking Station 4000 Setup utility as follows.
1. Follow the instructions in Chapter 2 and dock your NEC
Versa on the Docking Station 4000 and power on.
2. Boot into Windows, if Windows is not already opened.
(Type win and press Enter to open Windows.)
3. Close any Windows applications that may be running
(for example, CardView or the NEC Battery Gauge).
4. Insert the first Docking Station 4000 Setup diskette into
the drive.
5. From the Windows Program Manager, access the File
pull-down menu and select Run.
6. Type a:winstall and press Enter or click “OK.”
7. Respond to the utility prompts as follows:
n After reading the wINSTALL message that intro-
duces the Docking Station 4000 Setup Utility, click
“OK” or press Enter to continue with the setup.
n Specify the disk drive on which to install the
software. Press Enter or click “OK” to accept the
default drive c:.
To Next Page
Loading...